Request a quote ↗
← All articles SIGNAGE · ORDERING GUIDE

How to Choose a Real Estate Sign That Fits Your Existing Frame

Measure the opening, check the panel thickness and match the rider before ordering a replacement sign.

A sign that measures 24 by 18 inches on paper can still bind in a slide-in frame or hang crooked on a post. Before ordering, take five minutes to check how the frame holds the sign. If you manage signs for multiple agents, save those measurements with a photo so the next reorder is easier.

Two-post frame with a panel held between rails and a separate bottom rider — AI-generated product mockup
Slide-in frame. Measure the opening, channel clearance and separate rider bay.
Two-post frame with a hanging panel and a top rider — AI-generated product mockup
Hanging panel. Measure the spacing between the two mounting holes.

AI-generated examples show two mounting styles. Measure your own frame before ordering.

1. Start with the mounting style

Look at what holds the main panel in place. A slide-in frame grips the edges in channels. A hanging post supports the panel from holes or clips. An H-stake slides into the open vertical flutes of corrugated plastic. An A-frame may have tabs, clips or a recessed insert bay. Take a straight-on photo and a close-up of the hardware before removing the old sign.

2. Measure the opening and the panel separately

Write dimensions as width × height. Measure the visible opening and, if you have the old panel, measure its full width, height and thickness. Those measurements can differ because part of the panel may sit behind a rail. For a slide-in frame, also check the clearance at the entry slot and how deep the channels grip the edges. For a hanging panel, measure the hole spacing from center to center and note how far the holes are from the top and side edges.

For example, a landscape panel measuring 24 inches wide by 18 inches high and a portrait panel measuring 18 inches wide by 24 inches high are different orders. Write the orientation on your measurement photo if your office uses both.

3. Match the material to the hardware

Corrugated plastic is a practical choice for wire stakes when the stake fits the flutes and the flutes run vertically. Aluminum composite is a rigid option for compatible slide-in or hanging hardware. PVC can work where its thickness and support suit the frame. If you’re switching materials, share the channel clearance and mounting details so we can check the fit and, for hanging signs, whether the hardware can carry the replacement panel.

4. Measure the rider on its own

The rider is the smaller strip that says Sold, Open House or the agent’s name. Note whether it goes above or below the main sign and how it attaches. Measure the actual rider or its holder rather than assuming it matches the panel width. A 24-inch-wide panel might take a 24 × 6 inch rider, but that depends on the holder and the hardware.

BrandMark Consulting supplies replacement panels, riders and complete sign kits in Maryland, DC and Virginia.

Explore Realty Signs ↗Request a Realty Signs quote